Laser radial xd rigging manual

throughout the XD system. Vectran 12 is a strand braided rope utilizing fibers made from liquid crystal polymer which give it a very high strength-to-weight ratio. Th e strands are formed to produce a solid plaited rope with a squarer profile. Th ey are balanced to distribute the loads equally, resist kinking and work well around turning blocks. Unpacking and Preparation: Laser, Radial Laser 2. Parts of the Laser 3. Hardware Location 4. Hardware Installation 5. Rigging the Traveler 6. Rigging the Mast 7. Stepping the Mast 8. Rigging the Outhaul 9. Rigging the Clew Tie-down Rigging the Vang Rigging the Cunningham Daggerboard Retainer Mast Retainer Line Rigging File Size: 1MB. How To Rig A Laser Sailboat in 5 Easy Steps Step 1 - Sail And Mast Assembly Lay the sail out flat then, put the upper mast and lower mast together (the upper mast and boom are the same for Std, Radial and rigs) it is a good idea to wrap a piece of rigging tape around the top of the upper mast as shown.

ILCA Home - International Laser Class Association. The Standard and Radial sails are on separate parts of the sail rack and are labelled accordingly. Rigging in the Yard Most of the rigging for the Laser is done in the yard and boat house. You should only move the boat onto the dock and into the water when you are ready to sail. With a little practice you should be able to rig and be off. - Please do not get creative with the rigging or you will confuse others. - Report any problems or damage. Rigged and ready: See picture. Here's the IBM laser rigged with the radial sail (note the ). About this document: Instructions originally by Andrew Craig. Updated, including adding pictures, by Brendan Blake.

The Standard and Radial sails are on separate parts of the sail rack and are labelled accordingly. Rigging in the Yard Most of the rigging for the Laser is done in the yard and boat house. You should only move the boat onto the dock and into the water when you are ready to sail. With a little practice you should be able to rig and be off. Unpacking and Preparation: Laser, Radial Laser 2. Parts of the Laser 3. Hardware Location 4. Hardware Installation 5. Rigging the Traveler 6. Rigging the Mast 7. Stepping the Mast 8. Rigging the Outhaul 9. Rigging the Clew Tie-down Rigging the Vang Rigging the Cunningham Daggerboard Retainer Mast Retainer Line Rigging. throughout the XD system. Vectran 12 is a strand braided rope utilizing fibers made from liquid crystal polymer which give it a very high strength-to-weight ratio. Th e strands are formed to produce a solid plaited rope with a squarer profile. Th ey are balanced to distribute the loads equally, resist kinking and work well around turning blocks.